Hello, We had a custom Map Basic application that was created for us. The application runs smoothly on my machine. Next, we wanted to install the application on a co-workers computer. We upgraded his version of MapInfo to 7.8, we did a whole new install, old version was 5.5. Then we ran the application on his machine. However when we went to load the workspace, the file did not load correctly because some of the files were read only. We looked in the layer control and noticed that all layers were greyed out if wanted to make them editable. Even if we selected the layer to be visible, it still cannot be edited. When we try to geocode an address, it tells us the layer is read-only and shuts the custom application down. We don't think it is the application as it runs fine on other machines, any ideas what could be going wrong??? Thanks in advance. Naz Ali | GIS Marketing Services CB Richard Ellis Limited 1111 West Georgia Street, Suite 600 | Vancouver, BC V6E 4M3 T 604 662 5173 | F 604 684 9368 <mailto:[EMAIL PROTECTED]> [EMAIL PROTECTED] | <http://www.cbre.com/> www.cbre.com
<http://www.cbre.com/cbre_logo.jpg>
