Hi all,
I have a simple region that I
have created using the following command;
Create Region Into
Variable oBand 1 4 (x1,y1) (x2,y2) (x3,y3) (x4,y4)
If I want to Alter oBand to
contain a second (or third...) region (with updated x1,y1, x2,y2,
x3,y3, x4,y4 values) how do I do this ?
Alter Object oBand
????? Add Position ?????
I'm lost so any help would be
greatly appreciated.
Many thanks.
Stuart
Visit our website at http://www.halcrow.com
------------------------------------------------------------------------
The contents of this email are confidential, for the sole use
of the intended recipient at the email address to which it has
been addressed and do not give rise to any binding legal
obligation upon Halcrow companies unless subsequently confirmed
on headed business notepaper sent by fax, letter or as an email
attachment. Whilst reasonable care has been taken to avoid virus
transmission, no responsibility for viruses is taken and it is
your responsibility to carry out such checks as you feel
appropriate. Emails supplied are as found and there's no
guarantee that the messages contained within the body of the
email have not been edited after receipt. If you receive this
email in error, please contact the sender immediately and delete
the message from your system.
Thank you.
-------------------------------------------------------------------------
_______________________________________________
MapInfo-L mailing list
[email protected]
http://www.directionsmag.com/mailman/listinfo/mapinfo-l
