I will work on this as a ESRI problem. I ran the getcapabilities through
a validator and it was valid
http://schemas.opengis.net/wms/1.1.1/WMS_MS_Capabilities.dtd
The "'" was shown as '
Jim
On 10/20/2010 02:27 PM, Paul Ramsey wrote:
Agreed. Well, might want to save out the capabilities document and run
it through an XML validator to make sure, but it sounds like we're the
Nice Guys here.
P
On Wed, Oct 20, 2010 at 11:24 AM, Bart van den Eijnden<[email protected]> wrote:
Try \' or ask ESRI :-)
It's not a Mapserver problem.
Best regards,
Bart
--
Looking for flexible support on OpenLayers or GeoExt? Please check out
http://www.osgis.nl/support.html
Bart van den Eijnden
OSGIS
[email protected]
On Oct 20, 2010, at 8:20 PM, jim wrote:
Paul,
I tried' and it has the same effect as a real "'".
Jim
On 10/19/2010 07:41 PM, Paul Ramsey wrote:
Try using' and see how it goes
On Tue, Oct 19, 2010 at 3:51 PM, jim<[email protected]> wrote:
I have a mapfile that has wms_title strings with single quotes. When I open
the WMS layer in Arcmap any layers with a single quote are not displayed
properly, with the string truncated after where the quote is.
How do I properly insert an apostrophe into a wms_title?
Jim White
_______________________________________________
mapserver-users mailing list
[email protected]
http://lists.osgeo.org/mailman/listinfo/mapserver-users
_______________________________________________
mapserver-users mailing list
[email protected]
http://lists.osgeo.org/mailman/listinfo/mapserver-users
_______________________________________________
mapserver-users mailing list
[email protected]
http://lists.osgeo.org/mailman/listinfo/mapserver-users
_______________________________________________
mapserver-users mailing list
[email protected]
http://lists.osgeo.org/mailman/listinfo/mapserver-users
