/* HINT: Search archives @ http://www.indyramp.com/masq/ before posting! */
I strongly disagree because although you cannot load the same module twice,
the same loaded module can be used several NICs. I believe that this is
simply a problem with the Ne2000 NICs and clones.
> -----Original Message-----
> From: Ross Brattain [SMTP:[EMAIL PROTECTED]]
> Sent: Tuesday, July 20, 1999 12:18 PM
> To: [EMAIL PROTECTED]
> Cc: [EMAIL PROTECTED]
> Subject: [Masq] Re: [Masq] Delaying eth1 initialization
>
> /* HINT: Search archives @ http://www.indyramp.com/masq/ before posting!
> */
>
>
>
> If you have two cards of the same type you need to compile the driver into
> the kernel and use the ether=10,0x300,eth0 type lilo parameters. I
> believe this is because you cannot load a module twice.
>
> On Tue, 20 Jul 1999, Kelly Scroggins wrote:
>
> > The /etc/conf.modules file has the correct info:
> > alias eth0 ne
> > options ne io=0x300 irq=10
> > alias eth1 ne
> > options ne io=0x320 irq=11
> > [maybe I need to give each board virtual name?]
> > =============
>
> After you recompile the kernel you would put a line like this in your
> lilo.conf:
>
> append="ether=10,0x300,eth0 ether=11,0x320,eth1"
>
>
> Ross Brattain
> [EMAIL PROTECTED]
>
>
>
>
> _______________________________________________
> Masq maillist - [EMAIL PROTECTED]
> Admin requests can be handled at http://www.indyramp.com/masq-list/
> or email to [EMAIL PROTECTED]
>
> PLEASE read the HOWTO and search the archives before posting.
> You can start your search at http://www.indyramp.com/masq/
_______________________________________________
Masq maillist - [EMAIL PROTECTED]
Admin requests can be handled at http://www.indyramp.com/masq-list/
or email to [EMAIL PROTECTED]
PLEASE read the HOWTO and search the archives before posting.
You can start your search at http://www.indyramp.com/masq/
