Hello,
You should get the same...
I think (but you need to check the code/manual) that in the data format
of one system B is used, and in the other B/2 (for pi-equivalent of a
line).
Another common mistake is the basis of the per unit calculation that
differs, but I don't think this was the problem.
Best regards,
Dirk
On 08/15/2012 10:16 AM, iman wrote:
Dear all,
I simulated my 16 bus system in both Matpower and PSAT, but the
results in some buses are considerably different.Should I get the same
result for power flow using different softwares?Or that is acceptable
because component modeling might be different ?
--
Best regards
Iman
--
IEEE Region 8 Membership Development Chair
IEEE Benelux Section MD, SAC and webmaster
