As I said before, there can be different ways of formulating and choosing the variables for an OPF. FERC has released a series of papers on OPF that may interest you. http://www.ferc.gov/industries/electric/indus-act/market-planning/opf-paper s.asp#p1
Thanks for the blessings :-) Shri -----Original Message----- From: "Bai, Wenlei" <[email protected]> Reply-To: MATPOWER discussion forum <[email protected]> Date: Fri, 29 Aug 2014 16:20:05 +0000 To: MATPOWER discussion forum <[email protected]> Subject: RE: control variables of 'runopf' >Thank you Shri! >so Matpower opf consider all bus voltage and all generator Q as control >variables? Why is that? >As far as I know only voltage of PV bus should be control variables and >reactive power Q of generators shouldn't be control variables either. > >Blessings, >Wenlei Bai >Electrical Engineering, Department of Electrical & Computer Engineering >Baylor University, One Bear Place #97356 >Waco, TX 76798-7356 >(254)405-3320 >[email protected] > > >________________________________________ >From: [email protected] >[[email protected]] on behalf of Abhyankar, >Shrirang G. [[email protected]] >Sent: Friday, August 29, 2014 9:19 >To: MATPOWER discussion forum >Subject: Re: control variables of 'runopf' > >Please read section 6.3 of the manual 'Extended OPF formulation'. > >Shri > >From: "Bai, Wenlei" <[email protected]> >Reply-To: MATPOWER discussion forum <[email protected]> >Date: Fri, 29 Aug 2014 03:09:56 +0000 >To: MATPOWER discussion forum <[email protected]>, >"[email protected]" <[email protected]> >Subject: RE: control variables of 'runopf' > > >>And I also want to ask how to modify control variables when running opf >>as user's need? >>Thank you for your help >> >>Wenlei Bai >>Electrical Engineering, Department of Electrical & Computer Engineering >>Baylor University, One Bear Place #97356 >>Waco, TX 76798-7356 >>(254)405-3320 >>[email protected] >> >> >> >>________________________________________ >>From: [email protected] >>[[email protected]] on behalf of Bai, Wenlei >>[[email protected]] >>Sent: Thursday, August 28, 2014 13:46 >>To: [email protected] >>Subject: control variables of 'runopf' >> >> >>Hi, I try to understand the control variables in 'runopf' >>when I execute results = runopf('case_ieee30'), the system has 6 >>generators, 2 Shunts, and 4 transformers. >>According to user manual, "resutls.x" are all the optimization variables >>(total 72), including Pg (6), Qg(6), Va(30), Vm(30), however voltage >>angles, and slack bus are not supposed to be control variables, and some >>additional variables, e.g. Shunts and transformers >> should be considered as control variables. >>Question: how to interpret the control variables (72 total) that >>Matpower shows to me? >> >> >>Wenlei Bai >>Electrical Engineering, Department of Electrical & Computer Engineering >>Baylor University, One Bear Place #97356 >>Waco, TX 76798-7356 >>(254)405-3320 >>[email protected] > > > > >
