Hi Samuel, Thank you for this insight.
On Wed, Nov 22, 2017 at 9:09 AM, Samuel Perkin <samu...@landsnet.is> wrote: > Hi Ahmad, > > > > As Ray said, Matpower doesn’t do distributed slack, but it isn’t too > difficult to simulate multiple slack buses by wrapping matpower load flow > functions in a loop. Here is some rough pseudocode to get you started: > > > > 1) Define generator participation factors > > 2) Run load flow in Matpower > > 3) Determine change in slack bus generation > > 4) Distribute this change in generation among generators, based on > their participation factors > > 5) Return to step 2 unless the change in slack bus is near-zero > > > > To ensure convergence, you may also need to account for changes in losses > (as you are trying to balance Generation = Load + Losses) > > > > Kind regards, > > > > Samuel > > > > > * Samuel Perkin * > Kerfisstjórnunarsvið / System Operations > Tel / Sími +354 563 / Mobile / Gsm. +354 / samu...@landsnet.is > > > > * www.landsnet.is <http://www.landsnet.is> / www.facebook.com/landsnet > <http://www.facebook.com/landsnet> / www.twitter.com/landsnethf > <http://www.twitter.com/landsnethf>* > > *From:* bounce-122061961-76238...@list.cornell.edu [mailto: > bounce-122061961-76238...@list.cornell.edu] *On Behalf Of *Ahmad Sadiq > Abubakar > *Sent:* 20. nóvember 2017 12:02 > *To:* MATPOWER discussion forum <matpowe...@list.cornell.edu> > *Subject:* Multiple Slack bus > > > > Dear all, > > Can I run power with multiple slack bus in matpower? > > > -- > > > *Engr. AHMAD, Abubakar Sadiq PhD Student* > > *Electrical Engineering.* > > *Bayero University, Kano. Nigeria.* > > *OR* > > > *Lecturer Electrical and Electronics Engineering,* > > *Federal University of Technology,* > > *P.M.B, 65, Minna.* > > *Nigeria*. > *+2347068043665* > -- *Engr. AHMAD, Abubakar Sadiq**PhD Student* *Electrical Engineering.* *Bayero University, Kano. Nigeria.* *OR* *LecturerElectrical and Electronics Engineering,* *Federal University of Technology,* *P.M.B, 65, Minna.* *Nigeria*. *+2347068043665*
