Thanks for your respond. Many regards.
Στις Κυρ, 20 Ιαν 2019, 01:52 ο χρήστης amir ali Hosseini < [email protected]> έγραψε: > Hi > i cab boy find problem . unless > negligible syntax! > [image: image.png] > > On Fri, Jan 18, 2019 at 12:17 AM Αμαλία Μαυρογιάννη <[email protected]> > wrote: > >> Yes, you are right, this is the version. >> The whole message is: >> Error using + >> Matrix dimensions must agree. >> >> Error in opf_setup (line 212) >> cpg(ip1) = cpg(ip1) + pcost(ip1, COST) * baseMVA; >> >> Error in opf (line 225) >> om = opf_setup(mpc, mpopt); >> >> Error in runopf (line 75) >> [r, success] = opf(casedata, mpopt); >> >> Error in Solve_run_uopf_opf (line 38) >> ropf = runopf(mpc, mpopt) >> >> I think the problem is that only one generator is active. >> >> Thanks for your respond. >> Amalia Mavrogianni. >> >> Στις Πέμ, 17 Ιαν 2019, 22:26 ο χρήστης Ray Zimmerman <[email protected]> >> έγραψε: >> >>> MATPOWER 7.1 does not exist. I assume you mean 7.0b1, right? >>> >>> Btw, I think you included the details of *where* the error occurs, but >>> not *what* the error message is. It might give us a clue. >>> >>> Ray >>> >>> >>> On Jan 17, 2019, at 2:10 PM, Αμαλία Μαυρογιάννη <[email protected]> >>> wrote: >>> >>> Thanks for your respond, >>> >>> I use Matpower 7.1. >>> >>> Many regards. >>> Amalia Mavrogianni >>> >>> Στις Πέμ, 17 Ιαν 2019, 22:04 ο χρήστης Ray Zimmerman <[email protected]> >>> έγραψε: >>> >>>> I am not able to reproduce the error below. What version of MATPOWER >>>> are you using? (type mpver to find out) >>>> >>>> Ray >>>> >>>> >>>> On Jan 13, 2019, at 5:33 AM, Αμαλία Μαυρογιάννη <[email protected]> >>>> wrote: >>>> >>>> Hello all, >>>> I have problem in my case with cost it says: >>>> Error in opf_setup (line 212) >>>> cpg(ip1) = cpg(ip1) + pcost(ip1, COST) * baseMVA; >>>> >>>> Error in opf (line 225) >>>> om = opf_setup(mpc, mpopt); >>>> >>>> Error in runopf (line 75) >>>> [r, success] = opf(casedata, mpopt); >>>> >>>> Error in Solve_run_uopf_opf (line 37) >>>> ropf = runopf(mpc, mpopt) >>>> >>>> If you run my M-file Solve_run_uopf_opf.m you will see the exact >>>> problem. Please help. >>>> >>>> Many regards. >>>> Amalia Mavrogianni >>>> <my_case.m><Solve_run_uopf_opf.m> >>>> >>>> >>>> >>>
