Hi Surbhi, Could you please check the continuity of the system before running opf? I mean to say if you run opf for (n-1) criteria the system should be still well connected. There shouldn't be any island within the system itself. Perhaps you can test your model by removing any one parallel line (which you can observe later for analysis) and run the model under (n-1) criteria. This could be the easiest way to test the model. Thank you.
Kind regards Mirish On Wed, Sep 9, 2020 at 9:11 AM Surbhi Aggarwal <[email protected]> wrote: > Dear All, > I am working on optimal power flow to find the contingency (N-1) situation > of the system. For some of the line outage, certain output pops out > > MATPOWER Version 7.0, 20-Jun-2019 -- AC Power Flow (Newton) > Warning: Matrix is singular to working precision. > > In mplinsolve (line 75) > In newtonpf (line 110) > In runpf (line 260) > Warning: Matrix is singular to working precision. > > In mplinsolve (line 75) > In newtonpf (line 110) > In runpf (line 260) > Warning: Matrix is singular to working precision. > > In mplinsolve (line 75) > In newtonpf (line 110) > In runpf (line 260) > Warning: Matrix is singular to working precision. > > In mplinsolve (line 75) > In newtonpf (line 110) > In runpf (line 260) > Warning: Matrix is singular to working precision. > > In mplinsolve (line 75) > In newtonpf (line 110) > In runpf (line 260) > Warning: Matrix is singular to working precision. > > In mplinsolve (line 75) > In newtonpf (line 110) > In runpf (line 260) > Warning: Matrix is singular to working precision. > > In mplinsolve (line 75) > In newtonpf (line 110) > In runpf (line 260) > Warning: Matrix is singular to working precision. > > In mplinsolve (line 75) > In newtonpf (line 110) > In runpf (line 260) > Warning: Matrix is singular to working precision. > > In mplinsolve (line 75) > In newtonpf (line 110) > In runpf (line 260) > Warning: Matrix is singular to working precision. > > In mplinsolve (line 75) > In newtonpf (line 110) > In runpf (line 260) > > Newton's method power flow (power balance, polar) did not converge in 10 > iterations. > > >>>>> Did NOT converge (7.38 seconds) <<<<< > > What to do to correct this error. It would be of great help. > Regards > Surbhi Aggarwal >
