Gidday All, I'm trying to run the NetConnect version of MD2 V1.4. I downloaded the full v1.4 and installed it, then replaced the executable with the NC2 version. After finding all the libraries with no version complaint MD2 goes into this endless sequence forever: (Snoopdos log) 3122 MicroDot #READ 83BC904, 877705C, C Work OK 3123 MicroDot #READ 83BC904, 877705C, C Work OK 3124 MicroDot #SEEK 83BC904, FD72, Work Fail 3125 MicroDot #READ 83BC904, 877705C, C Work OK 3126 MicroDot #READ 83BC904, 877705C, C Work OK 3127 MicroDot #SEEK 83BC904, FD72, Work Fail 3128 MicroDot #READ 83BC904, 877705C, C Work OK 3129 MicroDot #READ 83BC904, 877705C, C Work OK 3130 MicroDot #SEEK 83BC904, FCC2, Work Fail 3131 MicroDot #READ 83BC904, 877705C, C Work OK 3132 MicroDot #READ 83BC904, 877705C, C Work OK 3133 MicroDot #READ 83BC904, 877705C, C Work OK 3134 MicroDot #READ 83BC904, 877705C, C Work OK 3135 MicroDot #READ 83BC904, 877705C, C Work OK 3136 MicroDot #SEEK 83BC904, FD72, Work Fail It is the same however it is started. All earlier versions of MD from 1.1 to 1.3 still run normally, but the non-NetConnect v1.4 does the same. V3 demo behaves very similarly except it gobbles all the memory until there are just a few kbytes of chipram left. Does anyone know why this is happening and how to fix it? -- Support *Open Directory Project* No Banners, No junk-just information. *ODP *is built by volunteers and owned by the community . *-------> http://dmoz.org <*-----------Check it out <sb> *Patrick Ford Auckland, New Zealand* */#fidonet#/ 3:772/235.3 #/icq#/ 51642681* <tsb>
