Well after tinkering for a bit last night with cables and what not, the
blame lay on the cable I was using. using another cable fixed the
volume/balance problem, and Im happily trying to figure out how to get
winamp to pop just enough silence between songs to keep my tracks seperate.
I remember reading mention of a silence plug in here yesterday I believe,
any more info on that from anyone? I pretty much do all my recording from
my computer, and this is the last hurdle I have at this point.
Thank you
Rahim
-----Original Message-----
From: Magic [mailto:[EMAIL PROTECTED]]
Sent: Tuesday, April 25, 2000 07:23
To: [EMAIL PROTECTED]
Subject: Re: MD: Balance problem when recording analog from crystal sound
card
This problem is usually caused by the cable you are using to connect your MD
to your sound card. Make sure that is is a stereo cable - it will have two
bands on the plug at each end not just one. If it is the right one it may be
that it has a fault, so try a different cable.
Magic
--
"Creativity is more a birthright than an acquisition, and the power of sound
is wisdom and understanding applied to the power of vibration."
Location : Portsmouth, England, UK
Homepage : http://www.mattnet.freeserve.co.uk
EMail : [EMAIL PROTECTED]
-----------------------------------------------------------------
To stop getting this list send a message containing just the word
"unsubscribe" to [EMAIL PROTECTED]
-----------------------------------------------------------------
To stop getting this list send a message containing just the word
"unsubscribe" to [EMAIL PROTECTED]
