Will give this a shot. Will report back in a bit once I get this setup and tested.
From: [email protected] [mailto:[email protected]] On Behalf Of Niall Brady Sent: Wednesday, September 25, 2013 9:46 AM To: [email protected] Subject: Re: [MDT-OSD] HP Revolve 810 and Bitlocker during OSD ok try adding a pause step before and after your enable bitlocker step like so CM12 in a Lab - How can I pause a task sequence in System Center 2012 Configuration Manager ?<http://www.windows-noob.com/forums/index.php?/topic/8846-how-can-i-pause-a-task-sequence-in-system-center-2012-configuration-manager/> then grab the smsts.log at this point, and attach it here. On Wed, Sep 25, 2013 at 4:35 PM, Linkey, Mike <[email protected]<mailto:[email protected]>> wrote: Well, looking at the log, it does not seem to go back far enough. But attached what is there. From: [email protected]<mailto:[email protected]> [mailto:[email protected]<mailto:[email protected]>] On Behalf Of Niall Brady Sent: Wednesday, September 25, 2013 9:23 AM To: [email protected]<mailto:[email protected]> Subject: Re: [MDT-OSD] HP Revolve 810 and Bitlocker during OSD well the first thing to check is what your smsts.log file tells you when you do any bitlocker specific steps, so what does it tell you ? attach it here if you wish On Wed, Sep 25, 2013 at 3:59 PM, Linkey, Mike <[email protected]<mailto:[email protected]>> wrote: We check the bois before we start and it is already enabled. From there whatever is in the task sequence by default and the MBAM 2.0 client take care of the rest. That is how we have done it with the normal laptops with Windows 7. If we put the Windows 7 image on these, it works like a champ. So it is just something with the Windows 8 TS. Just can't seem to find that needle in the hay stack at this point. From: [email protected]<mailto:[email protected]> [mailto:[email protected]<mailto:[email protected]>] On Behalf Of Niall Brady Sent: Wednesday, September 25, 2013 8:52 AM To: [email protected]<mailto:[email protected]> Subject: Re: [MDT-OSD] HP Revolve 810 and Bitlocker during OSD aer you enabling the tpm as part of your task sequence ? are you using any vendor specific tools to do this ? On Wed, Sep 25, 2013 at 3:45 PM, Linkey, Mike <[email protected]<mailto:[email protected]>> wrote: We have just got some HP Revolve 810 Tablets/laptops. We have our Windows 8 image setup and working to some extent. We can install the operating system with it just fine. When we enable the bitlocker stuff, Bitlocker will not work. We can't enable it or anything. We also are installing the MBAM 2.0 client. That install works fine, but again it will not start encrypting the drive. So thinking there was some incompatibility, we decide to just use the Windows 8 DVD to install the OS as a test and it worked as advertised. We can enable Bitlocker no problem. So I have been scratching my head now trying to figure out what is different. What would keep Bitlocker from working? It almost seems like the TPM chip can't be detected after using the OSD image, but it does work with just using the DVD to install. Anyone have experience with these that can give us some pointers? Not sure where to go with it at this point. Mike L.
