Just on some 9020 AIO's. Most are fine, but a handful reboot when loading PXE. It's perplexing.
Mark Kent (MCP) Sr. Desktop Systems Engineer Computing & Technology Services - SUNY Buffalo State From: [email protected] [mailto:[email protected]] On Behalf Of Keith Garner (Hotmail) Sent: Wednesday, July 9, 2014 7:24 PM To: [email protected] Subject: RE: [MDT-OSD] RE: Optiplex 9020 AIO issue Are you getting mysterious reboots on the same machines, or random machines? If the machines are rebooting during WinPE, then the best course of action is to press F8 and check the smsts.logs et al From: [email protected]<mailto:[email protected]> [mailto:[email protected]] On Behalf Of Kent, Mark Sent: Wednesday, July 9, 2014 1:13 PM To: [email protected]<mailto:[email protected]> Subject: [MDT-OSD] RE: Optiplex 9020 AIO issue I've cleared out all references. We did about 50 in one lab, 45 were fine but 5 keep restarting in WinPE. These 9020's (both the regular towers/SFF's and the AIO) have been rather quirky with SCCM. Mark Kent (MCP) Sr. Desktop Systems Engineer Computing & Technology Services - SUNY Buffalo State From: [email protected]<mailto:[email protected]> [mailto:[email protected]] On Behalf Of Krueger, Jeff Sent: Wednesday, July 9, 2014 3:43 PM To: [email protected]<mailto:[email protected]> Subject: [MDT-OSD] RE: Optiplex 9020 AIO issue Bare metal build? Sounds like it's not recognizing them as an unknown computer (assuming you TS is advertised to unknown machines). Grab the MAC address and query that in the DB see if you get any results From: [email protected]<mailto:[email protected]> [mailto:[email protected]] On Behalf Of Kent, Mark Sent: Wednesday, July 9, 2014 3:29 PM To: [email protected]<mailto:[email protected]> Subject: [MDT-OSD] Optiplex 9020 AIO issue We have just set up close to 50 of these devices. All of them imaged just fine (SCCM 2012 R2, MDT2013) except for 5 of them. When you PXE boot them, they load WinPE to the point where a message pops up that it's preparing network connections. This goes away immediately, and about 10 seconds later it reboots. If we boot from USB, it fully boots into WinPE and does get a network connection, but when you click next on the task sequence box, it immediately says that there are no task sequences advertised to the device (which makes no sense). Has anyone come across any particulars with this model? Thanks. Mark Kent (MCP) Sr. Desktop Systems Engineer Computing & Technology Services - SUNY Buffalo State ________________________________ CONFIDENTIALITY NOTICE: This email contains information from the sender that may be CONFIDENTIAL, LEGALLY PRIVILEGED, PROPRIETARY or otherwise protected from disclosure. This email is intended for use only by the person or entity to whom it is addressed. If you are not the intended recipient, any use, disclosure, copying, distribution, printing, or any action taken in reliance on the contents of this email, is strictly prohibited. If you received this email in error, please contact the sending party by reply email, delete the email from your computer system and shred any paper copies. Note to Patients: There are a number of risks you should consider before using e-mail to communicate with us. See our Privacy & Security page on www.henryford.com<http://www.henryford.com> for more detailed information as well as information concerning MyChart, our new patient portal. If you do not believe that our policy gives you the privacy and security protection you need, do not send e-mail or Internet communications to us.
