On a Dell Optiplex 980, when booting from a USB stick with a WinPE 5.1 image created by SCCM 2012/MDT 2013 I am not getting an IP address.
I am pretty sure I have the correct driver loaded in the WIM, but for some reason it is not loading correctly and then I do not get an IP address. I am able to find the correct driver in the X:\Windows\INF folder in the Boot Wim when booted from the stick as "OEM28.inf" - so the driver is injected properly as far as I can tell. I am able to load the driver using "drvload oem28.inf" from a command prompt. When I load the driver in this way and do "wpeutil initializeNetwork" then I get an IP address. So I think I have the right driver in there, but it is just not being detected correctly. Does anyone have any tips? I am pretty sure the ven/dev code for the Ethernet device in the Optiplex 980 is 8086/10EF- and that code is listed as supported in the driver that gets loaded by adding the drivers to the WIM (as evidenced by OEM28.inf ________________________________ Notice: This UI Health Care e-mail (including attachments) is covered by the Electronic Communications Privacy Act, 18 U.S.C. 2510-2521, is confidential and may be legally privileged. If you are not the intended recipient, you are hereby notified that any retention, dissemination, distribution, or copying of this communication is strictly prohibited. Please reply to the sender that you have received the message in error, then delete it. Thank you. ________________________________
