Hi Scott, You can insert the logic of H(120) - this will halt the job for 120 seconds. You place this within a macro called at the beginning of your report using the AL START footnote to pause the report at the very beginning. You can use any number of seconds within the argument.
Good luck, Kenny Whiteside Kenny Whiteside BSN, RN Patient Care Information Systems Catawba Valley Medical Center 810 Fairgrove Church Road Hickory, NC 28602 [EMAIL PROTECTED] >>> "Zimmerman, Scott" <[EMAIL PROTECTED]> 02/06/07 10:50 AM >>> Hello All, Is there a way to insert a deliberate time delay on a report. I actually want my report's macro to pause for a couple of minutes before continuing. Thank you in advance, Scott Zimmerman Laboratory Information Systems Analyst UMass Memorial Medical Center Department of Hospital Labs Office: 508-334-7237 Page: 508-426-2178 (mailto:[EMAIL PROTECTED] <mailto:[EMAIL PROTECTED]> ) <html><body><i>The information transmitted is intended only for the person or entity to which it is addressed and may contain confidential and/or privileged material. Any review, transmission, re-transmission, dissemination or other use of, or taking of any action in reliance upon this information by persons or entities other than the intended recipient is prohibited. If you received this in error, please contact the sender and delete the material from any computer.</i></body></html> =*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*= To subscribe or unsubscribe to the meditech-l, visit MTUsers.COM. To check the status of the meditech-l, visit MTUsers.NET. For help, email [EMAIL PROTECTED] ______________________________________ meditech-l mailing list [email protected] http://mtusers.com/mailman/listinfo/meditech-l
