No, I checked, I'm using the correct one (took the kernel-n900 from current MeeGo:1.1:Core:Testing)
But again, it might have been a battery issue on my end, I really don't know... I saw in another email thread that there were indeed problems, but that was: "twl4030 patch does have introduce a new issue so that n900 display doesn't work once power on after a power off." Not sure if it's realted or not... rs On 10/14/10 10:25 PM, "Carsten Munk" <[email protected]> wrote: Will verify this asap - Might you have used the wrong vmlinuz? /Carsten 2010/10/15 Selbak, Rolla N <[email protected]>: > When I tested this on the n900, the kernel booted, but it didn't boot to X, > it just went to a login prompt. Then when I booted again, it rebooted over > and over... > > It might be a battery issue on my end, but have you seen this behavior? > > rs > > > On 10/14/10 7:52 AM, "Peter Zhu" <[email protected]> wrote: > > Hi Yong Wang, > The following change has been accepted. See the changelog below. > > Comments: > Thank you > > Thanks, > MeeGo Release Engineering Team > > [This message was auto-generated] > --- > Request #8420: > > submit: devel:kernel:1.1/kernel(r3) -> MeeGo:1.1:Core:Testing/kernel > > > Message: > N900: Fix poweroff failure BMC #6090; Fix boot hang issue on Lenovo > Ideapad S10-3 BMC #7093 > > State: accepted 2010-10-14T07:52:47 peter > Comment: Thank you > > > History: new 2010-10-14T01:58:29 ywang > _______________________________________________ > Meego-commits mailing list > [email protected] > http://lists.meego.com/listinfo/meego-commits > > _______________________________________________ > MeeGo-packaging mailing list > [email protected] > http://lists.meego.com/listinfo/meego-packaging > _______________________________________________ MeeGo-packaging mailing list [email protected] http://lists.meego.com/listinfo/meego-packaging
