Do you use a symmetry plane parallel to the resonator? If so, the discretized geometry should fit in half the resonator's length, or you will run into the same problem.
Robert On 25-May-11 12:58, Waldemar wrote: >> Hi Waldemar, >> >> Is the length of the resonator also 1 after discretization? In other >> words, does the step size fit an integer times between the two plates? >> If not, MEEP will make it fit and therefore change the actual length of >> the resonator. >> >> Robert > > Thank you very much Robert, I tried resolutions of 11 an 13, now with > resolution > of 10 I get maxima at 0.5 and 1.47, still missing 1.50. > But I don't understand which step size should fit between the plates, because > my > spatial unit is 1 and the space between the plates is also 1, it should always > fit regardless of the resolution? > > Waldemar > > Robert Moerland <rjm_meep@...> writes: > > > > > _______________________________________________ > meep-discuss mailing list > [email protected] > http://ab-initio.mit.edu/cgi-bin/mailman/listinfo/meep-discuss _______________________________________________ meep-discuss mailing list [email protected] http://ab-initio.mit.edu/cgi-bin/mailman/listinfo/meep-discuss
