Cheers feral errol. I just read in one of my manuals that anything over
.005 would have to be machined flush so i should be alright.
Craig
>From: "Errol Smith" <[EMAIL PROTECTED]>
>Reply-To: [EMAIL PROTECTED]
>To: <[EMAIL PROTECTED]>
>Subject: Re: Timing cover - block clearance
>Date: Fri, 21 Apr 2000 21:54:21 +1000
>
>Craig, I think the gasket could absorb the 0.004" easily as a normal
>crushed thickness for most gaskets is approx 0.040"
>Cheers
>Feral Errol
>
>----------
> > From: Craig Harris <[EMAIL PROTECTED]>
> > To: [EMAIL PROTECTED]
> > Subject: Timing cover - block clearance
> > Date: Friday, April 21, 2000 8:10
> >
> > hi
> >
> >
> > Just wandering if the timing cover is around 004 inch above the block if
> > this would affect the the head gasket making a proper seal? or not?
> >
> > Cheers Craig
> > ________________________________________________________________________
> > Get Your Private, Free E-mail from MSN Hotmail at http://www.hotmail.com
> >
>
________________________________________________________________________
Get Your Private, Free E-mail from MSN Hotmail at http://www.hotmail.com
--membersozdat-------------------------------------------------------
OZDAT Mailing List Please Note:-
Send (un)subscribe requests to [EMAIL PROTECTED]
Send submissions to [EMAIL PROTECTED]
No unauthorised redistribution of this email
http://www.datascribe.com.au/ozdatonline/index.htm
http://www.datascribe.com.au/ozdatonline/listindex.html
---------------------------------------------------------------------
