Mick,
I usually have my sets of con rods and sometimes cranks x-rayed before
machining. It doesn't often save me money on machining bad bits but does
give peace of mind. Costs are typically $80 per plate (4 rods or 1 crank)
Cheers
Feral Errol
----------
> From: Mick Ralph <[EMAIL PROTECTED]>
> To: [EMAIL PROTECTED]
> Subject: Re: X ray
> Date: Tuesday, May 02, 2000 7:19
>
> thanks errol
> have u had to do this?
> cheers
> mick
>
> ----- Original Message -----
> From: Errol Smith <[EMAIL PROTECTED]>
> To: <[EMAIL PROTECTED]>
> Sent: Tuesday, May 02, 2000 6:59 AM
> Subject: Re: X ray
>
>
> > Mick,
> > Go to your nearest light aircraft engineering firm and they should be
able
> > to arrange it for you.
> > Cheers
> > Feral Errol
> >
> > ----------
> > > From: Mick Ralph <[EMAIL PROTECTED]>
> > > To: [EMAIL PROTECTED]
> > > Subject: X ray
> > > Date: Tuesday, May 02, 2000 12:38
> > >
> > > i have to get my brake pedal x-rayed as it has been welded for the
> tilton
> > > balance bar and it has also been lengthened
> > > its been stomped on for about 10 years and hasn't broken but
apparently
> > > because it is a brake component that has been welded it has to be x
> rayed
> > > I am on the gold coast
> > > anyone know of a place where i could get this done
> > > i am happy to send the pedal anywhere to get it done
> > > help please??
> > > cheers mick
> > >
> >
>
--membersozdat-------------------------------------------------------
OZDAT Mailing List Please Note:-
Send (un)subscribe requests to [EMAIL PROTECTED]
Send submissions to [EMAIL PROTECTED]
No unauthorised redistribution of this email
http://www.datascribe.com.au/ozdatonline/index.htm
http://www.datascribe.com.au/ozdatonline/listindex.html
---------------------------------------------------------------------
