Chris the simplest is to get the electronic dissy out of a Series 2 bluebird
these are pretty cheap and give excellent results in most Dattos also get
electronic coil with it There are 2 wire from dissy to coil and if you get both
together leave them hooked up then remove ballast resistor and coil from your
car install dissy and coil and connect Black and White power wire to + sie of
coil and away you go
Peter
Chris Halpin wrote:
> does anyone have any recommendations on distributors for by fresh L16 that
> I'm about to install? It's basically a blueprinted engine, but I would like
> one that I can transfer to a farily worked L18 soon, and one that will
> perform well under these conditions.... are twin point's the way to go?
> Looking for something relatively bargain-ish, although I would prefer to get
> something decent worth a bit more than cheap and nasty - hey I can live on
> maggie noodles and rain-water for a while...
>
> chris
> ________________________________________________________________________
> Get Your Private, Free E-mail from MSN Hotmail at http://www.hotmail.com
>
> This message comes to you from the Datsun 510 mailing list.
> List rules and instructions are available at:
> http://bluebirds.datsun510.com/bluebirds/listcharter
> Authors retain implicit copyright to their material. Obtain
> permission from the author before redistributing messages.
>
--membersozdat-------------------------------------------------------
OZDAT Mailing List Please Note:-
Send (un)subscribe requests to [EMAIL PROTECTED]
Send submissions to [EMAIL PROTECTED]
No unauthorised redistribution of this email
http://www.datascribe.com.au/ozdatonline/index.htm
http://www.datascribe.com.au/ozdatonline/listindex.html
http://www.mail-archive.com/[email protected]/
---------------------------------------------------------------------
