--membersozdat------------------------------------------------------- OZDAT Mailing List Please Note:- Send (un)subscribe requests to [EMAIL PROTECTED] Send submissions to [EMAIL PROTECTED] No unauthorised redistribution of this email http://www.datascribe.com.au/ozdatonline/index.htm http://www.datascribe.com.au/ozdatonline/listindex.html http://www.mail-archive.com/[email protected]/ ---------------------------------------------------------------------
Andrew, I slotted both the inside mounts on the xmember vertically and the outside horizontally, and yes they both need to be done to allow the movement in the a-arms. I slotted them on the inside by drilling a new hole vertical of the existing hole then using a "sideways drill" that i got from hardwarehouse to shape the hole properly, the outside holes i only opened up horizontally slightly. I then used a steel die grinding bit to clean up the holes. also im running trx rims and my rear end is around 2 " lower than standard, the camber now is slightly positive without driver and dead flat with me in it! Pretty good results just need to get a proper alignment done after i lower it again. Cheers Steve. Andrew Kubenk wrote: > steve, > i was wondering as i am about to slot my xmember, did you only slot the inside > vertically or did you also slot the outside horizontally? everything i have > ever read always slot both the "pivots" and i would love to know how you did > it, also how lowered is your beast and how far did the wheels straighten up? > and how long are the slots and how did you slot them. basic questions i know > but as they say, knowledge is power. > thanks in advance for the reply, email to the list so we can all learn from > your experience. > > Warmest Regards > > Andrew Kubenk > > [EMAIL PROTECTED] > [EMAIL PROTECTED]
