I have seen these used on a friends car. They are not very strong in my
opinion. They are easily bent and when they are bent you might as well not
have them.
Russ
----- Original Message -----
From: "James Swann" <[EMAIL PROTECTED]>
To: <[EMAIL PROTECTED]>
Sent: Thursday, June 22, 2000 2:16 PM
Subject: Bump Steer
> G'day all,
>
> Just adding my five cents
>
> I have read by using ecentric (or offset) pins that run through your
crossmember/ lowercontrol arm by rotating these so the ecentric part is at
the top not bottom (these I use in my 1600 to change the camber on the front
end) it changes the height of the control arm in relation to the crossmember
thus can reduce bump steer on a lowered 1600 to a certain degree. Basicly
what it does is the control arm located higher due the off set on the pin, I
read about this on one of the american 1600 websites but can't remember
which one but it's linked to the ozdat site.
>
> I am going to try the theory above when I put my 1600 back together cos I
love it very low
>
> Cheers to Terry for the part number and thanks bruce of your help, you've
got a list of part numbers is that correct????
>
> James :)
>
>
>
--membersozdat-------------------------------------------------------
OZDAT Mailing List Please Note:-
Send (un)subscribe requests to [EMAIL PROTECTED]
Send submissions to [EMAIL PROTECTED]
No unauthorised redistribution of this email
http://www.datascribe.com.au/ozdatonline/index.htm
http://www.datascribe.com.au/ozdatonline/listindex.html
http://www.mail-archive.com/[email protected]/
---------------------------------------------------------------------
