Gilby,
1600 (P510) Nissan workshop manual says:
Lower balljoint to control arm 18 ft/lbs
balljoint retaining nuts 55 ft/lbs
Terry
-----Original Message-----
From: [EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED]]On Behalf Of Gilby Bonza
Sent: Tuesday, 27 June 2000 12:53 PM
To: [EMAIL PROTECTED]
Subject: Torque wrench settings
I am hoping someone out there can help me with the torque wrench settings
for a ball joint and inner tie rod end ball joint. For a 180b sss I'm sure
there the same as a 1600. Thanks.
________________________________________________________________________
Get Your Private, Free E-mail from MSN Hotmail at http://www.hotmail.com
--membersozdat-------------------------------------------------------
OZDAT Mailing List Please Note:-
Send (un)subscribe requests to [EMAIL PROTECTED]
Send submissions to [EMAIL PROTECTED]
No unauthorised redistribution of this email
http://www.datascribe.com.au/ozdatonline/index.htm
http://www.datascribe.com.au/ozdatonline/listindex.html
http://www.mail-archive.com/[email protected]/
---------------------------------------------------------------------
