you could trial and error it? i didn't break my tacho doing that but probably
not what you want..
Try to look on the circuit board for a + and a -. they would be your power and
the other goes to the negative of the coil.
I would assume the two white ones are power and the other is the signal..
never done it on a 1600 tho..
good luck
- Julian
Ryan Boylan wrote:
> Hi guys I am trying to install a tacho into my 1600 but I'm a bit confused.
> It is a "standard" tacho for a 1600 I think, well it fits into the dash
> anyway. Well my question is where do the wires go? There are two white wires
> and a smaller green wire. How do I know which one goes to the coil etc.
>
> Thanks in advance
> Ryan
>
> ________________________________________________________________________
> Get Your Private, Free E-mail from MSN Hotmail at http://www.hotmail.com
>
--membersozdat-------------------------------------------------------
OZDAT Mailing List Please Note:-
Send (un)subscribe requests to [EMAIL PROTECTED]
Send submissions to [EMAIL PROTECTED]
No unauthorised redistribution of this email
http://www.datascribe.com.au/ozdatonline/index.htm
http://www.datascribe.com.au/ozdatonline/listindex.html
http://www.mail-archive.com/[email protected]/
---------------------------------------------------------------------
