RE: pipe bends

[Jim Jones]

My advice would be not to use mild steel as it delaminates quite badly on the inside and the only place it goes is through your motor.  Stainless steel would be a much wiser choice. -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]On Behalf Of Andrew Peters Sent: Monday, 4 September 2000 20:33 To: [EMAIL PROTECTED] Subject: pipe bends almost finished the car, i just need some 2.5" mild steel mendrel bends for ic plumbing, anyone, Davo mainly, got any idea what they are worth each, or do they vary in price depending on the bend? thanks andrew --membersozdat------------------------------------------------------- OZDAT Mailing List Please Note:- Send (un)subscribe requests to [EMAIL PROTECTED] Send submissions to [EMAIL PROTECTED] No unauthorised redistribution of this email http://www.ozdat.com/ozdatonline/index.htm http://www.ozdat.com/ozdatonline/listindex.html http://www.mail-archive.com/membersozdat@datascribe.com.au/ --------------------------------------------------------------------- --membersozdat------------------------------------------------------- OZDAT Mailing List Please Note:- Send (un)subscribe requests to [EMAIL PROTECTED] Send submissions to [EMAIL PROTECTED] No unauthorised redistribution of this email http://www.ozdat.com/ozdatonline/index.htm http://www.ozdat.com/ozdatonline/listindex.html http://www.mail-archive.com/membersozdat@datascribe.com.au/ ---------------------------------------------------------------------