Chris,
Unless it has an 8 plug dissy, you would have to check the length of the
dissy drive by pulling out your dissy!. All 8 plug dissies I have seen have
the long dissy shaft (93 mm). If you have the long shaft dissy, you need to
change drive shafts. If the dissy shaft is 32mm then just change over the
dissy.
Cheers
Feral Errol
mailto:[EMAIL PROTECTED]
http://www.datrats.com.au/
-----Original Message-----
From: [EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED]]On Behalf Of FJ MAN
Sent: Saturday, December 30, 2000 0253
To: [EMAIL PROTECTED]
Subject: Re: Z18ET Z20E Ignitions
errol,
i have an L20 bottom end on me z18, would the mods be the same depending on
if the Lseries shaft was already in or not? I happen to have a series 2
dizzy lieing about :). How do u go about the coil just change them over as
you would and L series"? Im doing the fuel supply for my z18et soon so if u
could email me privately on what u may have thats suitable for the
conversion it'd be appreciated before i go out n spend more money than i
have to :)
regards chris
_________________________________________________________________________
Get Your Private, Free E-mail from MSN Hotmail at http://www.hotmail.com.
--membersozdat-------------------------------------------------------
OZDAT Mailing List Please Note:-
Send (un)subscribe requests to [EMAIL PROTECTED]
Send submissions to [EMAIL PROTECTED]
No unauthorised redistribution of this email
http://www.ozdat.com/ozdatonline/index.htm
http://www.ozdat.com/ozdatonline/listindex.html
http://www.mail-archive.com/[email protected]/
---------------------------------------------------------------------
