Andy,
Some good resources for motor specs are:
Jason Gray's Motorspecs page
http://home.att.net/~jason510/Motorspecs.htm
& cylinder head specs
http://bre510.com/SSS.htm
- Tom
PS I don't think a 210 head would be a very good choice for a L20b bottom
end, very small ports. I'd say if you want high compression, fit a W53
(with its small 39cc chambers) maybe with port work depending on the
application
-----Original Message-----
From: [EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED]]On Behalf Of Andy Nielsen
Sent: Wednesday, 21 February 2001 2:56 PM
To: [EMAIL PROTECTED]
Subject: Motor info.....
I finally got a chance to have a fiddle with that engine calculator but I
can't work out some of the values. I was trying to work out the compression
if you put a 210 (stocko 1600 head) on a L20 bottom end. Can anyone help.
Standard L20 Block
Piston pin height?
Piston dish?
Standard 210 Head
Combustion Chamber Volume?
_________________________________________________________________________
Get Your Private, Free E-mail from MSN Hotmail at http://www.hotmail.com.
--membersozdat-------------------------------------------------------
OZDAT Mailing List Please Note:-
Send (un)subscribe requests to [EMAIL PROTECTED]
Send submissions to [EMAIL PROTECTED]
No unauthorised redistribution of this email
http://www.ozdat.com/ozdatonline/index.htm
http://www.ozdat.com/ozdatonline/listindex.html
http://www.mail-archive.com/[email protected]/
---------------------------------------------------------------------
