I just pulled the ignition switch from my 1600 and removed the barrel.Is
there any way of removing the switch itself to clean the contact or do I
have to replace it.Also it was hot when I removed it after 5 minutes of
running.I measured the voltage from the pos on the coil to an earth
which read 12v but it was a bit eratic.Should be 12v constant shouldn't
it?Could this cause a weak spark.
Andrew Smith
--membersozdat-------------------------------------------------------
OZDAT Mailing List Please Note:-
Send (un)subscribe requests to [EMAIL PROTECTED]
Send submissions to [EMAIL PROTECTED]
No unauthorised redistribution of this email
http://www.ozdat.com/ozdatonline/index.htm
http://www.ozdat.com/ozdatonline/listindex.html
http://www.mail-archive.com/[email protected]/
---------------------------------------------------------------------
