Ichiban in Syndey refer a bloke that makes factory looms, from scratch for
$3-400, give them a call and they should give you his details.
The CA conversion isn't bolt in, but is fairly easy, can be done for not
much over $2k, but very stock, and with a cheap wrecked engine in unkown
condition. I'll give you all the details if needed as I know this conversion
very well.
Jon
-------------------------------------------------------
DatNet - Online Datsun Resource
Website: http://www.datnet.org
Jon Ovington - [EMAIL PROTECTED]
Matt Spiteri - [EMAIL PROTECTED]
-----Original Message-----
From: [EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED]]On Behalf Of Pig
Sent: Tuesday, 29 May 2001 10:38 PM
To: [EMAIL PROTECTED]
Subject: Also some more CA18DET questions
My friends CA18DET loom had been cut when the motor was ripped out of the
donor car...thats
probably why he got the motor for $800. I'm sure he said he had to buy a new
wiring loom for $800.
Does that sound correct, and if so I will begin production of the wiring
looms post haste.
Also, since no one wants to buy my 89 Pulsar I might as well add some bits
to it. I hear a front wheel
drive CA motor is an easy conversion into the Pulsars?
P.W.J. Stanley (aka Pig, Pop)
www.pwjstanley.com
--membersozdat-------------------------------------------------------
OZDAT Mailing List Please Note:-
Send (un)subscribe requests to [EMAIL PROTECTED]
Send submissions to [EMAIL PROTECTED]
No unauthorised redistribution of this email
http://www.ozdat.com/ozdatonline/index.htm
http://www.ozdat.com/ozdatonline/listindex.html
http://www.mail-archive.com/[email protected]/
---------------------------------------------------------------------
