Adam
I'll do it for you, $90 I have the pipe already cut to length, you want 3'
or 4' hole???
I'm in melbourne
Peter
0418314872
----- Original Message -----
From: "Adam Jackson" <[EMAIL PROTECTED]>
To: <[EMAIL PROTECTED]>
Sent: Friday, July 06, 2001 8:07 AM
Subject: Re: rear X member mods
> Cam,
>
> hmmm well if you only cut thru the stone tray and it was rooted, how on
> earth has everyone else cut thru the X member? The bloke i spoke to wants
to
> plasma cut the hole etc etc... reinforce bits and pieces, but to me it
looks
> like it would take less than an hour or 2 for an experienced welder to do
> the entire job and $200 is far too expensive...
>
> I did try a sheet metal place but they wouldn't ahve a bar of it as it was
> to do with a car and didn't want any legal ramifications if things went
> wrong...
>
> looks like i either foot the bill or do it myself...
>
> cheers,
>
> Adam
>
>
> Um, you can have mine .....
>
> It's rooted tho, you couldn't cut paper with it now. Would you believe I
> only used it to cut two holes in my stone tray (air inlet for my pod
filter)
>
> It cost me about $50 and used it twice :(
>
> I ended up getting the local sheet metal place to plasma cut the opening
of
> the crossmember, re-weld in the 4" pipe, plasma cut the A arm mounting
> points to allow for adjustable camber all for $120. (which is still to
dear
> in my book but anyway)
>
> Just take it to a local sheet metal joint and pay them for the headaches.
>
> Cam
>
>
>
--membersozdat-------------------------------------------------------
OZDAT Mailing List Please Note:-
Send (un)subscribe requests to [EMAIL PROTECTED]
Send submissions to [EMAIL PROTECTED]
No unauthorised redistribution of this email
http://www.ozdat.com/ozdatonline/index.htm
http://www.ozdat.com/ozdatonline/listindex.html
http://www.mail-archive.com/[email protected]/
---------------------------------------------------------------------
