Title: RE: output from knock sensor
|
hi, i just remembered that there might have been
a diy kit for a knock sensor ( including a diy sensor !!) in either a old
issue of electronics australia, or silicon chip magazine, might be worth
emailing them to ask.
mark k
----- Original Message -----
Sent: Tuesday, November 13, 2001 12:09
PM
Subject: RE: output from knock
sensor
Thanks, I think I might use a
microphone attached to the block and a filter instead of a knock sensor.
As the knock sensors filter out certain frequencies depending what car they
were made for.
-----Original Message-----
From: mark
krawczuk [SMTP:[EMAIL PROTECTED]]
Sent: 13/11/2001
11:04
To: [EMAIL PROTECTED]
Subject: output from knock sensor
hi, i was looking at a zoom magazine and it had a
holden knock sensor, and
the out put from
that was about 2.6 volt...
mark k
--membersozdat-------------------------------------------------------
OZDAT Mailing List Please Note:-
Send (un)subscribe requests to
[EMAIL PROTECTED]
Send submissions to
[EMAIL PROTECTED]
No unauthorised redistribution of this
email
http://www.ozdat.com/ozdatonline/index.htm
http://www.ozdat.com/ozdatonline/listindex.html
http://www.mail-archive.com/[email protected]/
---------------------------------------------------------------------
--membersozdat-------------------------------------------------------
OZDAT Mailing List Please Note:-
Send (un)subscribe requests to [EMAIL PROTECTED]
Send submissions to [EMAIL PROTECTED]
No unauthorised redistribution of this email
http://www.ozdat.com/ozdatonline/index.htm
http://www.ozdat.com/ozdatonline/listindex.html
http://www.mail-archive.com/[email protected]/
--------------------------------------------------------------------- |
