Ok sweet well I am going to invest in that Medium street cam power between 3000 - 6500 so I will most probibly need to change lashpad thicknesses and yes i am getting the valve seats replaced with hardened seats for running Premium-ULP in her.
so all should bee sweet. And yes it is in Frank H's book that's where I got the Idea from. Chris. > Chris, > > I have 44mm inlets in my U67 head. Valve lenghts were slightly > different. Sorry I don't remember the measurements, but they were > shorter. You will probably need new seats too. Depending on the > installed height of the valves in the seats you may need new lash pads > and this may depend on your cam etc. > > EG I am using 170thou lash pads at the moment with a std cam. Normally > you would only use 118thou lash pads but due to valve lenght and the > depth of the cut on the valve seat, the lash pads need to be thicker to > correct the rocker arm geometry. > > Cheers > Trev > > > -----Original Message----- > From: Chris Williams [mailto:[EMAIL PROTECTED]] > Sent: Thursday, 29 November 2001 11:03 > To: [EMAIL PROTECTED] > Subject: Zed car valves + crowcams > > > Hi, > Has any one here put L series six cylender valves from Zed cars in > an > L20B > head to get bigger valves. If yes are the valve lengths the same? > > Also has any one put a 30721 CrowCam Medium street performance in an > L20B head? > > Cheers Chris > > --membersozdat------------------------------------------------------- OZDAT Mailing List Please Note:- Send (un)subscribe requests to [EMAIL PROTECTED] Send submissions to [EMAIL PROTECTED] No unauthorised redistribution of this email http://www.ozdat.com/ozdatonline/index.htm http://www.ozdat.com/ozdatonline/listindex.html http://www.mail-archive.com/[email protected]/ ---------------------------------------------------------------------
