yeah the piston and the seal went in but then got stuck half way down the bore.
-----Original Message----- From: mark krawczuk [mailto:[EMAIL PROTECTED]] Sent: Monday, 10 December 2001 17:58 To: [EMAIL PROTECTED] Subject: Re: master cylinder rebuild hi, not shure if i understand ya right though, but some times u might have to use a blunt instrument, (biro, rounded of nail etc..) and put slight pressure on the piston and poke the seal in bit by bit. mark k ----- Original Message ----- From: "Shane McManus" <[EMAIL PROTECTED]> To: <[EMAIL PROTECTED]> Sent: Monday, December 10, 2001 8:56 AM Subject: master cylinder rebuild > i have a wee problem. > ive pulled my 1600 master cylinder down for a rebuild. > ive got all the rite seals ect but when i go to put the first piston in it > jams when u get the last seal in ( if u can follow). > how tight should new seals b. > bearing in mind that i covered in brake fluid. > cheers > > > --membersozdat------------------------------------------------------- OZDAT Mailing List Please Note:- Send (un)subscribe requests to [EMAIL PROTECTED] Send submissions to [EMAIL PROTECTED] No unauthorised redistribution of this email http://www.ozdat.com/ozdatonline/index.htm http://www.ozdat.com/ozdatonline/listindex.html http://www.mail-archive.com/[email protected]/ ---------------------------------------------------------------------
