hi, i know that on some twin cylinders there is a small bolt that screws from inside the resivoir ,down into the cyl bore, and this stops the piston going any further. but since u got a new one ...........................................
mark k ----- Original Message ----- From: "Shane McManus" <[EMAIL PROTECTED]> To: <[EMAIL PROTECTED]> Sent: Tuesday, December 11, 2001 8:16 AM Subject: RE: master cylinder rebuild > nah its a twin cylinder. > its stuck for good tho. i took it to a brake place and the tried to hydrolic > it out but no good. > so i ended up getting a brand spanking one > > -----Original Message----- > From: mark krawczuk [mailto:[EMAIL PROTECTED]] > Sent: Tuesday, 11 December 2001 10:20 > To: [EMAIL PROTECTED] > Subject: Re: master cylinder rebuild > > > hi, i presume its a single master cyl? i rebuilt mine in about5 minutes. > maybr theres some rust down the bore? maybe your pushing it down to far so > it cant go any further.? i THINK there MIGHT be a small tab to bend down > on a washer thingy behind a seal, MAYBE its not bent down and hooking on the > resivoir inlet hole. have u got the right pistins etc....? > > > it should be a straight forward fittment, other than that i cant see why u > have a problem............. > > > mark k > > ----- Original Message ----- > From: "Shane McManus" <[EMAIL PROTECTED]> > To: <[EMAIL PROTECTED]> > Sent: Tuesday, December 11, 2001 6:09 AM > Subject: RE: master cylinder rebuild > > > > yeah the piston and the seal went in but then got stuck half way down the > > bore. > > > > -----Original Message----- > > From: mark krawczuk [mailto:[EMAIL PROTECTED]] > > Sent: Monday, 10 December 2001 17:58 > > To: [EMAIL PROTECTED] > > Subject: Re: master cylinder rebuild > > > > > > hi, not shure if i understand ya right though, but some times u might > > have to use a blunt instrument, (biro, rounded of nail etc..) and put > > slight pressure on the piston and poke the seal in bit by bit. > > > > > > mark k > > > > > > ----- Original Message ----- > > From: "Shane McManus" <[EMAIL PROTECTED]> > > To: <[EMAIL PROTECTED]> > > Sent: Monday, December 10, 2001 8:56 AM > > Subject: master cylinder rebuild > > > > > > > i have a wee problem. > > > ive pulled my 1600 master cylinder down for a rebuild. > > > ive got all the rite seals ect but when i go to put the first piston in > it > > > jams when u get the last seal in ( if u can follow). > > > how tight should new seals b. > > > bearing in mind that i covered in brake fluid. > > > cheers > > > > > > > > > > > > > > > > > > > > > --membersozdat------------------------------------------------------- OZDAT Mailing List Please Note:- Send (un)subscribe requests to [EMAIL PROTECTED] Send submissions to [EMAIL PROTECTED] No unauthorised redistribution of this email http://www.ozdat.com/ozdatonline/index.htm http://www.ozdat.com/ozdatonline/listindex.html http://www.mail-archive.com/[email protected]/ ---------------------------------------------------------------------
