RE: Z series confusion

[E Smith]

The L20 had probably been rebored 1mm. Z20 stock bore 85mm. L20 stock bore 85mm.   Cheers Feral Errol   -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]On Behalf Of David Costello Sent: Thursday, 10 January 2002 9:58 AM To: Ozdat Mailing List Subject: Z series confusion   guys I have a Z20 block, and some L20B rods and pistons the pistons don't fit into the bore of the Z20 block but that doesn't make sense, according to Jason Gray's site the L20 are a smaller bore than the Z20   I'm confused :( --membersozdat------------------------------------------------------- OZDAT Mailing List Please Note:- Send (un)subscribe requests to [EMAIL PROTECTED] Send submissions to [EMAIL PROTECTED] No unauthorised redistribution of this email http://www.ozdat.com/ozdatonline/index.htm http://www.ozdat.com/ozdatonline/listindex.html http://www.mail-archive.com/membersozdat@datascribe.com.au/ --------------------------------------------------------------------- --membersozdat------------------------------------------------------- OZDAT Mailing List Please Note:- Send (un)subscribe requests to [EMAIL PROTECTED] Send submissions to [EMAIL PROTECTED] No unauthorised redistribution of this email http://www.ozdat.com/ozdatonline/index.htm http://www.ozdat.com/ozdatonline/listindex.html http://www.mail-archive.com/membersozdat@datascribe.com.au/ ---------------------------------------------------------------------