Re: Cat convertors - help

[Daniel Kroehn]

I paid 180 bucks for my 3 inch cat but that was just for the cat.  I don't know what it will cost to put flanges on etc.  I put my cat under the tailshaft with the input just to the rear of the output on the gearbox.  The heat shield sits about 5mm below the tailshaft.  I put it back that far as I reckon that thats the spot that will give the best ground clearance.  If you have it too close to the floorpan, the floor can heat up to a really high temp, so be careful about placement.   Daniel Kroehn ----- Original Message ----- From: Nick Hering - Ferrit To: [EMAIL PROTECTED] Sent: Sunday, March 17, 2002 11:02 PM Subject: Cat convertors - help List, wot is the goin rate to hav a cat convertor installed - i wanna take the hotdog out and get it put in there - just after the turbo dump. It would need sum flanges etc put on to. Thanx Nick Hering The Ferrit '71 Datsun 1600 Z18ET Turbo Support http://www.ozdat.com http://www.datrats.com.au http://www.datnet.org   Send and receive Hotmail on your mobile device: Click Here --membersozdat------------------------------------------------------- OZDAT Mailing List Please Note:- Send (un)subscribe requests to [EMAIL PROTECTED] Send submissions to [EMAIL PROTECTED] No unauthorised redistribution of this email http://www.ozdat.com/ozdatonline/index.htm http://www.ozdat.com/ozdatonline/listindex.html http://www.mail-archive.com/membersozdat@datascribe.com.au/ --------------------------------------------------------------------- --membersozdat------------------------------------------------------- OZDAT Mailing List Please Note:- Send (un)subscribe requests to [EMAIL PROTECTED] Send submissions to [EMAIL PROTECTED] No unauthorised redistribution of this email http://www.ozdat.com/ozdatonline/index.htm http://www.ozdat.com/ozdatonline/listindex.html http://www.mail-archive.com/membersozdat@datascribe.com.au/ ---------------------------------------------------------------------