Andrew, You should adjust the drums in the correct manner first i.e. as per the handbook (release handbrake cable etc). It's normal for a Nabco or Tokico dual master not allowing the pedal to go all the way to the floor as there is a mechanical stop screw in the base of the master cylinder to prevent the piston from going past a certain point. Remember to bleed the line which is the longest from the cylinder first. I seem to always do the rears first, but in theory with a dual m/cyl it shouldn't make any difference.
regards Terry -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]On Behalf Of GREENBURY, Andrew Robert Sent: Sunday, 29 September 2002 11:37 PM To: [EMAIL PROTECTED] Subject: brake system problem? Hi guys, I was bleeding my brakes today after a fair period of non-use, but the pedal would not go all the way to the floor. Is this normal???? The setup is 240K twin spots on the front, 1600 drums on the rear, nabco 7/8" master and 180b booster... Thanks for any help, Andrew --membersozdat------------------------------------------------------- OZDAT Mailing List Please Note:- Send (un)subscribe requests to [EMAIL PROTECTED] Send submissions to [EMAIL PROTECTED] No unauthorised redistribution of this email http://www.ozdat.com/ozdatonline/index.htm http://www.ozdat.com/ozdatonline/listindex.html http://www.mail-archive.com/[email protected]/ ---------------------------------------------------------------------
