Hi Andrew The 180B tank fits with simple mods and the fuel intake system bolts in without mods.
You need to make a couple of simple brackets to raise the tank side supports about 30mm higher (from memory) than their current hight, to accommodate the deeper tank. You also need to trim metal off each side of the tank outside the serrations along the joint of the top and bottom halves, as the 180B tank is just too wide to squeeze between the strut towers until the edges are trimmed. The 180B fuel sender unit is totally compatible. It plugs in and reads accurately. Rick Clough Ph: 03 5172 2670 email: [EMAIL PROTECTED] ********************************************************************** Any personal or sensitive information contained in this email and attachments must be handled in accordance with the Victorian Information Privacy Act 2000, the Health Records Act 2001 or the Privacy Act 1988 (Commonwealth), as applicable. This email, including all attachments, is confidential. If you are not the intended recipient, you must not disclose, distribute, copy or use the information contained in this email or attachments. Any confidentiality or privilege is not waived or lost because this email has been sent to you in error. If you have received it in error, please let us know by reply email, delete it from your system and destroy any copies. ********************************************************************** --membersozdat------------------------------------------------------- OZDAT Mailing List Please Note:- Send (un)subscribe requests to [EMAIL PROTECTED] Send submissions to [EMAIL PROTECTED] No unauthorised redistribution of this email http://www.ozdat.com/ozdatonline/index.htm http://www.ozdat.com/ozdatonline/listindex.html http://www.mail-archive.com/[EMAIL PROTECTED]/ ---------------------------------------------------------------------
