hi....... errol are u implying that   malcom has TWO??????
 
mark k
----- Original Message -----
From: E Smith
Sent: Sunday, July 06, 2003 1:57 PM
Subject: RE: L Series extractors wanted!!!!!

What size are yours Malcolm : - )
 

Cheers,
Feral Errol
Get Serious tm<http://www.datrats.com.au/>

-----Original Message-----
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]On Behalf Of Maldat
Sent: Sunday, July 06, 2003 1:21 PM
To: [EMAIL PROTECTED]
Subject: Re: L Series extractors wanted!!!!!

I have spare sets of headers.
The ones I allways grab have long pipes into a 4-1 under the floor,and after a week of use take them off and file out the inside were you can see soot around the flange hole at the head end.
Makes a wicked difference,(match port,to a small degree).
 
They look to be the same shape as Comp headers as used on bob sharps 240Z but 4 cly.
 
I know I have a spare used set that has been chromed.
shipping ant cheap on headers,the L6 bob sharp ones from the states ,the shipping was more than the headers.
Malcolm
----- Original Message -----
From: Jimmy
Sent: Saturday, July 05, 2003 8:04 PM
Subject: RE: L Series extractors wanted!!!!!

Errol
 
I just measured em up for you.
 
There are four pipes, obviously, in rectangualr shape. They are 1.5" x 1.3" unfortunately :)
 
cheers
 


E Smith <[EMAIL PROTECTED]> wrote:
Jimmy,
The 1.75" or 1.875" diameter is the outside diameter of the primary pipes along a straight section. Thanks
Feral Errol
Get Serious tm<http://www.datrats.com.au/>

-----Original Message-----
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]On Behalf Of Jimmy
Sent: Friday, July 04, 2003 9:25 AM
To: [EMAIL PROTECTED]
Subject: RE: L Series extractors wanted!!!!!

Errol
 
I have a set of genie extractors for an l series.
I am not sure of the measurements.
 
Tell me where to take them and I will do it tomorrow
 
cheers

E Smith <[EMAIL PROTECTED]> wrote:
I am looking for some big primary pipe (1.75" or 1.875")L series extractors
in good nick, if any one can help? Please PM me if you have some thanks.

Cheers,
Feral Errol
Get Serious tm



-----Original Message-----
From: [EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED] Behalf Of amr
Sent: Thursday, July 03, 2003 5:31 PM
To: Ozdat
Subject: FW: VG30 parts wanted
Importance: High




Hi Guys

Anyone selling 2 exhaust headers and a short plenum for a vg30e i think
they are off a 300zx (but not sure), what i need is for the exhaust not
to cross over the bell housing of the gearbox and the short plenum
(inlet manifold) so I can get the engine as far back as possible

Thanks
Anthony






--membersozdat-------------------------------------------------------
OZDAT Mailing List Please Note:-
Send (un)subscribe requests to [EMAIL PROTECTED]
Send submissions to [EMAIL PROTECTED]
No unauthorised redistribution of this email
http://www.ozdat.com/ozdatonline/index.htm
http://www.ozdat.com/ozdatonline/listindex.html
http://www.mail-archive.com/[EMAIL PROTECTED]/
---------------------------------------------------------------------



Yahoo! Mobile
- Check & compose your email via SMS on your Telstra or Vodafone mobile.
--membersozdat-------------------------------------------------------
OZDAT Mailing List Please Note:-
Send (un)subscribe requests to [EMAIL PROTECTED]
Send submissions to [EMAIL PROTECTED]
No unauthorised redistribution of this email
http://www.ozdat.com/ozdatonline/index.htm
http://www.ozdat.com/ozdatonline/listindex.html
http://www.mail-archive.com/[EMAIL PROTECTED]/
---------------------------------------------------------------------
--membersozdat-------------------------------------------------------
OZDAT Mailing List Please Note:-
Send (un)subscribe requests to [EMAIL PROTECTED]
Send submissions to [EMAIL PROTECTED]
No unauthorised redistribut i! ! on of this email
http://www.ozdat.com/ozdatonline/index.htm
http://www.ozdat.com/ozdatonline/listindex.html
http://www.mail-archive.com/[EMAIL PROTECTED]/
---------------------------------------------------------------------



Yahoo! Mobile
- Check & compose your email via SMS on your Telstra or Vodafone mobile.
--membersozdat-------------------------------------------------------
OZDAT Mailing List Please Note:-
Send (un)subscribe requests to [EMAIL PROTECTED]
Send submissions to [EMAIL PROTECTED]
No unauthorised redistribution of this email
http://www.ozdat.com/ozdatonline/index.htm
http://www.ozdat.com/ozdatonline/listindex.html
http://www.mail-archive.com/[EMAIL PROTECTED]/
---------------------------------------------------------------------

--membersozdat-------------------------------------------------------
OZDAT Mailing List Please Note:-
Send (un)subscribe requests to [EMAIL PROTECTED]
Send submissions to [EMAIL PROTECTED]
No unauthorised redistribution of this email
http://www.ozdat.com/ozdatonline/index.htm
http://www.ozdat.com/ozdatonline/listindex.html
http://www.mail-archive.com/[EMAIL PROTECTED]/
---------------------------------------------------------------------
--membersozdat-------------------------------------------------------
OZDAT Mailing List Please Note:-
Send (un)subscribe requests to [EMAIL PROTECTED]
Send submissions to [EMAIL PROTECTED]
No unauthorised redistribution of this email
http://www.ozdat.com/ozdatonline/index.htm
http://www.ozdat.com/ozdatonline/listindex.html
http://www.mail-archive.com/[EMAIL PROTECTED]/
---------------------------------------------------------------------

--membersozdat-------------------------------------------------------
OZDAT Mailing List Please Note:-
Send (un)subscribe requests to [EMAIL PROTECTED]
Send submissions to [EMAIL PROTECTED]
No unauthorised redistribution of this email
http://www.ozdat.com/ozdatonline/index.htm
http://www.ozdat.com/ozdatonline/listindex.html
http://www.mail-archive.com/[EMAIL PROTECTED]/
---------------------------------------------------------------------

Reply via email to