|
1/4 bsp?
Kris.
----- Original Message -----
Sent: Friday, September 19, 2003 5:34
PM
Subject: RE: Barb thread
Yes,
I bought one today from Enzed. It's just a ordinary screw-in tapered
thread, 90degree 1/4" barb. I think it's a 1/4" thread.
You
can easily pull the old one out of the pump using a shifter, takes about 30
seconds.
Hi All,
Does
anyone know the barb thread on the S2 BB electric fuel pump? I want to
change mine from the 6mm to the 8mm outlet.
Kris. --membersozdat-------------------------------------------------------
OZDAT Mailing List Please Note:- Send (un)subscribe requests to
[EMAIL PROTECTED] Send submissions to
[EMAIL PROTECTED] No unauthorised redistribution of this
email http://www.ozdat.com/ozdatonline/index.htm
http://www.ozdat.com/ozdatonline/listindex.html
http://www.mail-archive.com/[EMAIL PROTECTED]/
--------------------------------------------------------------------- --membersozdat-------------------------------------------------------
OZDAT Mailing List Please Note:- Send (un)subscribe requests to
[EMAIL PROTECTED] Send submissions to
[EMAIL PROTECTED] No unauthorised redistribution of this
email http://www.ozdat.com/ozdatonline/index.htm
http://www.ozdat.com/ozdatonline/listindex.html
http://www.mail-archive.com/[EMAIL PROTECTED]/
---------------------------------------------------------------------
--membersozdat-------------------------------------------------------
OZDAT Mailing List Please Note:-
Send (un)subscribe requests to [EMAIL PROTECTED]
Send submissions to [EMAIL PROTECTED]
No unauthorised redistribution of this email
http://www.ozdat.com/ozdatonline/index.htm
http://www.ozdat.com/ozdatonline/listindex.html
http://www.mail-archive.com/[EMAIL PROTECTED]/
--------------------------------------------------------------------- |