no bad scrape marks. it looks slightly pitted but that's about it. ----- Original Message ----- From: "mark krawczuk" <[EMAIL PROTECTED]> To: <[EMAIL PROTECTED]> Sent: Monday, June 14, 2004 7:49 PM Subject: Re: Button Clutch Question...
> hi, as long as the clamping pressure is okay ,if it was me i`d get some > 80 grit sandpaper and go over the pressure plate... > are there any scraping marks on the rivets that hold the pucks? > > mark k > ----- Original Message ----- > From: <[EMAIL PROTECTED]> > To: <[EMAIL PROTECTED]> > Sent: Monday, June 14, 2004 5:40 PM > Subject: Button Clutch Question... > > > > I need help. This clutch is out of my SR20det. It's done about 5000km and > > i'm about to put the motor back in. > > I am putting in a new lightened flywheel. > > > > Take a look at the pics below and tell me what you would do. I am > stumped!!! > > Replace the clutch & pressure plate, or just throw it back in. > > > > large image (757k) > > http://www.mlmillionaire.com/910/clutch.JPG > > > > or small image (40k) > > http://www.mlmillionaire.com/910/clutch1.JPG > > > > > > > > > > > > > --membersozdat------------------------------------------------------- OZDAT Mailing List Please Note:- Send (un)subscribe requests to [EMAIL PROTECTED] Send submissions to [EMAIL PROTECTED] No unauthorised redistribution of this email http://www.ozdat.com/ozdatonline/index.htm http://www.ozdat.com/ozdatonline/listindex.html http://www.mail-archive.com/[EMAIL PROTECTED]/ ---------------------------------------------------------------------
