Loren, I found that I could get a lot of dirt and gunk out of the cylinder just by soaking it. I cleaned up two of them about 18 months ago and they still seem to be better than before.
I also used compressed air repeatedly to blow out the dirt and cleaner. Don't remember what I used for cleaner, but something like mineral spirits should do. I either used silicone spray or a light coat of white grease. Richard Murdoch 82 240D 82 300TDt 83 300Dt (parts car, no longer rolling) 79 240D waiting for transplant > > From: Loren Faeth <[EMAIL PROTECTED]> > Date: 2005/07/05 Tue PM 08:59:25 EDT > To: Mercedes mailing list <[EMAIL PROTECTED]> > Subject: [MBZ] 123 Ign lock Q > > For a late model 123 ign lock (The one with a face about 3/4 inch dia as > opposed to the older 3/8 inch exposed face) I'd like to know how to get the > wafers out of the lock. I have the lock out of the car in my hand. THere > is a pin on the side, just behind the face that looks like it might be the > key to disassemble, but I can't get the pin to move with the ksy in any > position, or in or out, and with the paper clip in or out for the outside > lug. Any pointers appreciated. I want to take the wafers out and clean it > good. > > Loren > > > _______________________________________ > For used parts email [EMAIL PROTECTED] > For new parts see www.buymbparts.com > For repairs see www.oldworldauto.com > > To Unsubscribe or change delivery options go to: > http://striplin.net/mailman/listinfo/mercedes_striplin.net >