Your photo page says you can make a Christmas card out of that pic!

Could you heat it up some with a torch to get it soft enough to pull out or would that goober up everything anyway?

--R

On 1/11/15 3:52 PM, Curt Raymond via Mercedes wrote:
As I said in my last message I finally yanked the engine that was stuck out of 
my snowmobile. When I was pulling it the carb was dripping gas (after I'd 
disconnected it) and I figured maybe it had a leaky seal and I was just dealing 
with a crank full of gas. Then I got it in the garage and actually looked into 
the exhaust...
http://i843.photobucket.com/albums/zz353/curtludwig/Snowmobiles/8c27a116-2f75-4cb6-b363-32bf32814057_zpsacca4761.jpg

I'd been using a piece of recoil rope to keep a piston from moving so the 
engine wouldn't rotate when I was trying to remove the clutch. I guess part of 
the rope got cut by the exhaust port and now its jammed in there good. I can't 
even wiggle the engine either way. The only way I can think to get it out is to 
take the jug off. I guess while I'm at it I'll throw a complete gasket kit into 
it, it won't take that much extra time. I was going to do crank seals anyway...
-Curt
_______________________________________
http://www.okiebenz.com

To search list archives http://www.okiebenz.com/archive/

To Unsubscribe or change delivery options go to:
http://mail.okiebenz.com/mailman/listinfo/mercedes_okiebenz.com

All posts are the result of individual contributors and as such, those 
individuals are responsible for the content of the post.  The list owner has no 
control over the content of the messages of each contributor.



_______________________________________
http://www.okiebenz.com

To search list archives http://www.okiebenz.com/archive/

To Unsubscribe or change delivery options go to:
http://mail.okiebenz.com/mailman/listinfo/mercedes_okiebenz.com

All posts are the result of individual contributors and as such, those 
individuals are responsible for the content of the post.  The list owner has no 
control over the content of the messages of each contributor.

Reply via email to