> On July 13, 2015 at 9:30 PM "Kaleb C. Striplin via Mercedes"
> <mercedes@okiebenz.com> wrote:
> 
> there is these metal collars on the base of the studs in that side of the head
> that sort of hold the gasket in a certain position. They were somewhat bent so
> I'm not sure if it was tightened too much bent them, or if the head was not
> down over them all the way or what. I think bottom line I must not have had
> the torque set right. I ordered a stud extractor and new stud but it will be
> next week before it shows up.


I'm guessing the head hung up on a dowel pin or two, and you bent a stud because
the head wasn't parallel to the block. 

_______________________________________
http://www.okiebenz.com

To search list archives http://www.okiebenz.com/archive/

To Unsubscribe or change delivery options go to:
http://mail.okiebenz.com/mailman/listinfo/mercedes_okiebenz.com

Reply via email to