Probably 

Sent from my iPhone

> On Jul 13, 2015, at 8:50 PM, Mitch Haley via Mercedes <mercedes@okiebenz.com> 
> wrote:
> 
> 
> 
>> On July 13, 2015 at 9:30 PM "Kaleb C. Striplin via Mercedes"
>> <mercedes@okiebenz.com> wrote:
>> 
>> there is these metal collars on the base of the studs in that side of the 
>> head
>> that sort of hold the gasket in a certain position. They were somewhat bent 
>> so
>> I'm not sure if it was tightened too much bent them, or if the head was not
>> down over them all the way or what. I think bottom line I must not have had
>> the torque set right. I ordered a stud extractor and new stud but it will be
>> next week before it shows up.
> 
> 
> I'm guessing the head hung up on a dowel pin or two, and you bent a stud 
> because
> the head wasn't parallel to the block. 
> 
> _______________________________________
> http://www.okiebenz.com
> 
> To search list archives http://www.okiebenz.com/archive/
> 
> To Unsubscribe or change delivery options go to:
> http://mail.okiebenz.com/mailman/listinfo/mercedes_okiebenz.com
> 

_______________________________________
http://www.okiebenz.com

To search list archives http://www.okiebenz.com/archive/

To Unsubscribe or change delivery options go to:
http://mail.okiebenz.com/mailman/listinfo/mercedes_okiebenz.com

Reply via email to