In a message dated 5/15/2006 8:28:21 P.M. US Mountain Standard Time, [EMAIL PROTECTED] writes:
Herr Doktor, how must one adjust the cable properly? Luther, My experience is with the rod, but cable adjustment should be similar. Shortening the cable will raise the shift points. You can do this gradually until the trans shifts at, or near, the marks in each gear with WOT. For a final check, on coast down, moving the shift lever from 4 to 3 should result in an immediate shift to 3. If it does not, you have the cable too short and must loosen it until the the down shift occurs. Look for a way to speed up the cable travel by lengthening the bell crank, to raise the shift points. Always count turns and take measurements so you can get back to your best settings. Regards, Jim Friesen Phoenix AZ 79 300SD, 262 K miles 98 ML 320, 142 K miles