Eh, it figures. I got the front right corner in the air and got underneath to 
get at the fog light. Bulb is dead and despite having a box full of all sorts 
of headlight bulbs, I have no 9006/HB4 bulbs. $40/pair at FLAPS or $20 
delivered tomorrow by the Island of Large Wimmen.

Delivery it is!

-D

> On Oct 7, 2023, at 3:43 PM, dan penoff.com via Mercedes 
> <mercedes@okiebenz.com> wrote:
> 
> Got some parts in for the CL600 this week, so I’ve been taking time here and 
> there to address the remaining issues.
> 
> Right rear brake light was out, which is a series of three circuit boards 
> with LEDs on them. Not sure why they did this other than maybe for brightness 
> without a lot of current, but every other lamp in the taillight assembly is a 
> standard incandescent lamp. Grrr.
> 
> Remove the taillight assembly and check the gasket for leaks (none! Yay!) 
> then remove the clamp that holds the three LED boards in place. Lift the 
> boards out and pull their socket and stab connectors apart. Reverse the 
> procedure and button things up. Right rear brake light is now functional! 
> Nice!
> 
> Another issue I have been dealing with is the ABS/ESP/BAS module not seeing 
> the signal from the right rear speed sensor. I replaced the original sensor 
> with a decent quality (Delphi, OE are NLA, third party are mostly junk) part, 
> but that did not resolve the issue. Dummy Me should have paid closer 
> attention rather than just looking at the condition of the original part and 
> assuming it was bad. Anyway, further (logical) troubleshooting transpired and 
> I “rang out” the harness from the plug at the sensor to the pin and socket 
> connector at the module. All tested well.
> 
> I snagged a used ABS module on eBay from a local seller. I did try cleaning 
> the connectors on the harness and original module first, but that didn’t 
> change anything. I swapped out the module with the used one, and after 
> resetting the BAS, the ABS light has gone out and remains out. Huzzah!
> 
> I’ve had a good run today so I think I may leave things as-is for now. I need 
> to replace a driving light bulb, which I might still do just to top things 
> off.
> 
> -D
> _______________________________________
> http://www.okiebenz.com
> 
> To search list archives http://www.okiebenz.com/archive/
> 
> To Unsubscribe or change delivery options go to:
> http://mail.okiebenz.com/mailman/listinfo/mercedes_okiebenz.com
> 

_______________________________________
http://www.okiebenz.com

To search list archives http://www.okiebenz.com/archive/

To Unsubscribe or change delivery options go to:
http://mail.okiebenz.com/mailman/listinfo/mercedes_okiebenz.com

Reply via email to