In a message dated 10/4/2007 3:09:22 P.M. US Mountain Standard Time, [EMAIL PROTECTED] writes:
Note the raised boss on the bearing cover which denotes the oil feed passage down to the front seal. the X should mark this location but some compressors did not have an X at all. You are in good shape if the clutch coil spade connectors are in line with the X as I believe most properly installed compressors have the coil spades facing up. WOW! I am not sure why a 40 meg picture ends up the size of a postage stamp. What can we do to fix this obvious shortcoming on our list. A good picture IS worth a thousand words. These were good when I sent them to the list. Is this AOL's fault? Jim Friesen Phoenix AZ 79 300SD, 264 K miles 98 ML 320, 152 K miles ************************************** See what's new at http://www.aol.com _______________________________________ http://www.okiebenz.com For new parts see official list sponsor: http://www.buymbparts.com/ For used parts email [EMAIL PROTECTED] To Unsubscribe or change delivery options go to: http://okiebenz.com/mailman/listinfo/mercedes_okiebenz.com