In a message dated 4/28/2008 9:26:31 P.M. US Mountain Standard Time, [EMAIL PROTECTED] writes:
Got a bad driveshaft vibration going down the highway. Would it be best to A: just swap in a complete driveshaft from a different car, B: pull driveshaft and have it balanced, or C: just keep moving the center section one notch at a time till it gets lined back up like it should be. Apparantly it was seperated at some point and not marked. kaleb, If this is your 560, somewhere about 88 they started match marking the two pieces of drive shaft at the factory. That don't mean yours is assembled right, it could have been assembled by someone with no concern for match marks. You have to have the drive shaft out to see the marks. Before removing it, seize the drive shaft near the support bearing and try to move it up and down. anymore than about an 1/8" of movement means the rubber support is shot. Good luck, Jim Friesen Phoenix AZ 79 300SD, 264 K miles 98 ML 320, 155 K miles **************Need a new ride? Check out the largest site for U.S. used car listings at AOL Autos. (http://autos.aol.com/used?NCID=aolcmp00300000002851) _______________________________________ http://www.okiebenz.com For new parts see official list sponsor: http://www.buymbparts.com/ For used parts email [EMAIL PROTECTED] To Unsubscribe or change delivery options go to: http://okiebenz.com/mailman/listinfo/mercedes_okiebenz.com