Might a very short Allen wrench on a universal joint with an extension shaft on a 1/4" ratchet help sufficiently with the expansion valve screws?
Wilton ----- Original Message ----- From: "Peter Frederick" <[EMAIL PROTECTED]> To: "Mercedes Discussion List" <mercedes@okiebenz.com> Sent: Wednesday, June 18, 2008 10:27 PM Subject: Re: [MBZ] 124 evapectomy > Good thing the new evaporator has a new expansion valve on it, eh? > > Actually, they aren't THAT bad so long as you are very careful to get > the allen wrench properly seated in the two screws that hold the > valve to the evaporator. > > I'll be challanging myself with this over the weekend or early next > week, as I plan to attempt a flush of my evaporator and want to > change the o-rings in any case -- new compressor and receiver/dryer > with a filter in the hose set -- don't see much point in NOT changing > all the o-rings at the same time! > > With any luck, I'll have a working ACC in a few days. > > Peter > > > _______________________________________ > http://www.okiebenz.com > For new parts see official list sponsor: http://www.buymbparts.com/ > For used parts email [EMAIL PROTECTED] > > To Unsubscribe or change delivery options go to: > http://okiebenz.com/mailman/listinfo/mercedes_okiebenz.com _______________________________________ http://www.okiebenz.com For new parts see official list sponsor: http://www.buymbparts.com/ For used parts email [EMAIL PROTECTED] To Unsubscribe or change delivery options go to: http://okiebenz.com/mailman/listinfo/mercedes_okiebenz.com